dcsimg
Rolatape

Rolatape Measuring Wheels

Lever Arm Installation Instructions

Please follow these instructions to install a lever arm. Improper installation may cause the counter not register or skip.

Model 400, Model 415 & Model 600

Bumper bracket must be mounted
on top of counter base.

(A)
This side toward counter

(B)
Bend here

(C)
Center here

(D)
Lever may need slight bending so that
contact is made approximately the center of wheel peos.

(A)
Pull lever arm back until rubber bumber is depressed.
Then tighten lock screw. It may be necessary to
reset lock screw to obtain this adjustment.

(B)
After screw is secure counter action should click app.
1/04“ to 1/16“ before lever contacts rubber bumber
at each end of stroke.

Note: If difficulty is experienced in making satisfactory repairs unit should be returned to factory for service.